Madoka Magica 2 Pachinko Machine Ejection Error

[Maily123]

I've converted my machine from a modded machine that had a chip back to it's original state and it seems to work fine up until around 40-50 balls have entered the main goal sensor then it gives an ejection error and doesn't let me proceed with playing. The mod was giving the same error so that's why I thought removing it and putting it back to stock would fix it but it doesn't. All the cables are plugged in except for 1 that's in the bottom left corner but there isn't any plugs for it so it makes me think that's its a leftover for another machine.

20240629_132430.jpg

[Drunkenclam]

Modern Kyorakus have a ball out sensor, to count the balls that enter then leave the start pocket. Its basically saying. Its not seeing balls leave the back of the cel after going through a pocket. Normally happens after about 50 spins. Common on Cyclic Kyorakus/Ok if not done properly.

[Maily123]

I checked all the sensors and none of them seem to be an issue at a glance. Whenever the error pops up on screen I get either a BL11, BL19 or BL20 error on the board.

[Maily123]

Update: I found where that random cable went but the downside is the Ejection Error now comes alot sooner since it's now counting the balls that miss.

[Drunkenclam]

Have the ball ways been modified. Also is this brought direct from a supplier. Is it as advertised.

[Maily123]

The pathways have been severely chopped up which was causing the issue. We had to do a whole bunch of trial and error to find out which path for the balls to take so the issue has been resolved now.

[Drunkenclam]

I believe only winning balls should pass through the out sensor.not missed balls