A Pachinko ball lifter, avoiding cyclic mod

[C-M-K]

I want a ball lifter but I don't want my machine to be cyclic modded in the process. The only solution I see is to get the machine to the shipping facility first, and then get the ball lifter after. Any other solutions?

[Ahab]

I bought my lifters from Rockston, a member of this forum. They were inexpensive and well made. I enjoy them very much.

[C-M-K]

But they're kits and I'd rather have a complete out of box lifter.

[PekoJPF]

Is there not a way to request the machine non-cyclic modded? Can get the ball lifter at the same time still. I think modded is just by default, but I'm sure you can ask for it not to be when purchasing.

[C-M-K]

Doesn't appear to be on the site.

[Ahab]

I bought my lifters complete and ready to run. I encourage you to inquire with Rockston.

[PekoJPF]

But this is just a Japanese rule. If you want to pay the ball on your home machine, we can arrange this.

Basically it can be arranged for machines to be non-cyclic.
That from A-Pachinko's FAQ on cyclic mode. So there we are. A-Pachinko has you covered, and Ahab also mentions that Rockston will have his lifters ready to run if desired. 2 options all yours.

[lotsoballs]

I like Silver brand lifters; bought off yahoo auctions. They are made for heavy parlor use and built very well, all metal construction. Proven reliability for decades. They have a cutoff switch once the upper hopper is full other models don’t have. You can still find NOS models never used before; or get a used one. They usually cost 20,000-30,000 yen.

Then combine that with a Daverob dongle/card reader emulator and you can dispense balls and add credits whenever you want for a parlor like experience.

[rockston]

The original side loader prototype is still running strong and is now connected
to my newest acquisition. The .99 cent NC switch installed on the left side of the frame
triggers the center feature and of course balls at your convenience. This is
an inexpensive home approach to aftermarket pachinko.

Coming next: I have a tiny inexpensive 2 channel remote control coming from China that I am going to install. The idea is to fix the shooter handle in a good position and have the receiver switch it to ground to fire balls. The second channel will be hooked up to the center feature. I should be able to trigger either option across the room while I'm watching TV and eating popcorn.
20220604_084554.jpg20220604_084534.jpg

[jasonlujan]

it is completely possible to get a payout machine and use a ball lifter - the two are not incompatible.