Will this Transformer work for my modern pachinko?

[phillymadison]

Hi all I'm still very new to modern pachinko machines and I have my first one coming in a few weeks. I know you need a 24v transformer. Would this one work? Thanks in advance
Packard Foot Mount Transformer Input120/208-240VA Output 40VA [Misc.] https://www.amazon.com/dp/B003CLBQKC..._KdOaybMWPDX4J

[Wayne-Ooo]

I don't think the one you posted will work.

The machine should run on 24V.

Should be 110/120V input to 24V output and probably at the least 6 amp. My Tom & Jerry machine has an 8 amp.

[Drunkenclam]

Although the spec is badly written and it does have a 24v output but, wow 40va. thats way to low. depending on how modern, you want 150va upwards

As above, I use 10A transformers on my machines. (I have 2x 500va transformers that run 2 machines each)

[takethecastle57]

http://www.ebay.com/itm/NEW-LARGE-9-...EAAOSwUuFWz319

[takethecastle57]

And if you want to do Major Power (20 Amps 24vac ) enough for 10 moderns

http://www.ebay.com/itm/ALTRONiX-ALT...U2w3sg1Az_AdjQ

[phillymadison]

Thanks guys I ended up with this one that was recommended to me on my orginal thread when I was looking for my modern machine.

https://blackhawksupply.com/collecti...cts/tr150va002

[Drunkenclam]

And if you want to do Major Power (20 Amps 24vac ) enough for 10 moderns

http://www.ebay.com/itm/ALTRONiX-ALT...U2w3sg1Az_AdjQ

Thats only 3.5A fuse per connector. A bit low for modern pachis

[takethecastle57]

Thats only 3.5A fuse per connector. A bit low for modern pachis

That's for the Separate 16 Channels . I do a Direct Hookup on the 24vac Power taps on the side ( Right by the Board ,Boards Green LED ) and I Splice in a Power strip on One of the two Boards ( Six Outlets ) with Surge protection and circuit breaker .

[samslack]

Ive had very good luck with the powervolt transformers they were deaigned for slots http://www.powervolt.com/slotmachine...rmers_smr.html



Sent from my SM-N920V using Tapatalk